Top Quality Waterproof Hiking Boots and Trail Accessories for Adventurers
Top Quality Waterproof Hiking Boots and Trail Accessories for Adventurers Top Quality Waterproof Hiking Boots and Trail Accessories for Adventurers
Cart(0)
Home Sensors Altitude Pressure Sensors
Product Details

Description

We stock a large number of barometric pressure sensors, and they all have slight differences: , , and . The Adafruit LPS28 (LPS28DFW) Pressure Sensor is unique in that it can handle a much higher range of pressures: almost every other sensor we've encountered tops out at about 1260 hPa. That means they're totally fine for measuring altitude for most human endeavours, we tend to stay above sea level. However, for some scientific or deep-water uses, 1260 will not cut it!  - that's as low as -43,000 feet below sea level in air or 40 meters underwater. 

, and liked it so much we turned it into a product!

That makes this a good sensor for use with underwater devices or robots, as it can tell your depth from the pressure readings. Of course, its also still a great sensor for altitude sensing out of the water: with a 24-bit sensor and the ability to discern absolute pressure changes of ±0.5 hPa at the highest quality readings, good for less than 1 centimeter of altitude. (Like all pressure sensors, the actual altitude-above-sea-level depends on the days' pressure at sea level) Or, if you need speed, it can do up to 200 samples per second, without filtering and averaging.

The sensor comes with a little metal port, so you could connect a thin tubing to it for measuring pressure far from where it is soldered. The sensor element within the package has potting gel good up to 10,000 hPa of pressure and protection against some harsh chemicals - .

To make life easier when working with this fancy sensor, we've taken the LPS28 and put it onto a breakout PCB along with support circuitry to let you use this little wonder with 3.3V (Feather/Raspberry Pi) or 5V (Arduino/ Metro328) logic levels. Additionally since it speaks I2C you can easily connect it up with two wires (plus power and ground!).  We've even included  compatible  connectors for the I2C bus so you don't even need to solder! Just wire up to your favorite micro and you can use our CircuitPython/Python or Arduino drivers to easily interface with the LPS28 and make approximate approximations of proximity in no time! QT Cable is not included, but we have a variety in the shop



Technical Details

LPS28DFW Specifications:

  • Dual full-scale absolute pressure with water-resistant package
    – Mode 1: 260 ~ 1260 hPa
    – Mode 2: 260 ~ 4060 hPa
  • Absolute pressure accuracy: 0.5 hPa
  • Low pressure sensor noise: 0.32 Pa
  • Embedded temperature compensation
  • 24-bit pressure data output
  • ODR from 1 Hz to 200 Hz
  • I²C or MIPI I3CSM interface
  • Embedded FIFO
  • Interrupt functions: data-ready, FIFO flags, pressure thresholds
  • Easily sealed package with O-ring
  • Default I2C address 0x5C, can be set to 0x5D

Product Dimensions: 25.4mm x 17.8mm x 4.8mm / 1.0" x 0.7" x 0.2"

Product Weight: 1.8g / 0.1oz



    Adafruit LPS28 (LPS28DFW) Pressure Sensor - STEMMA QT / Qwiic
    • Localstock
    • Overseasstock

    $ 22.86

    $ 22.86

    Please select combo product attributes
    The combo subtotal is $,SAVE$
    Unavailable
    You May Also Like
    Cart
    Top Quality Waterproof Hiking Boots and Trail Accessories for Adventurers
    Your cart is currently empty.